Roadtrek CS Adventurous Owner's Manual page 109

HOWTO: Waste Water Dumping
• • Close the black water tank valve by pushing in on the handle.
• • Open the grey water tank gate valve by pulling the grey handle out. It will come out approximately 1 1/2 inches (4 cm) and
stop.
• • Press and hold the waste water pump red button until the grey waste tank is empty.
• • Close the gray tank valve by pushing it back in to the original position.
Open the black valve
Always dump the black tank first and the gray tank second. The graywater will help flush any remaining solids from
the dump hose. If you wish to rinse the system, pour water down the toilet and sink, and dump again.
• • Close the sewage discharge valve on the end of the sewage hose.
• • Rinse off the dump area and the dump hose.
• • Return the sewage hose to its storage compartment by pushing the green hose back onto the reel.
• • Add about ½ gallon of fresh water to the black tank. While you`re doing this, add a packet of black holding tank chemicals
to the tank.
Do not toss the packet into the toilet, even if it claims to be `dissolvable`. It may not be dissolvable enough for the
macerator. Tear open the packet and pour the contents into the black tank, and dispose of the packet in the trash. The
contents of the powder packets can be irritating to your eyes and nose, so hold the packet low to the bowl and try to
pour directly into the tank.
Open the gray valve
© 2015 by Roadtrek, Inc.
106