Table of Contents
Advertisement
Eradicator Gen II O
Gen II O
Installation
EOG II Wire Harness Assembly
Motor
Power
Plug
Meter
Plug
Plug
Drive bracket
notches
8
with Ozone
3
Circuit board
locking tab
1.
On the circuit board, unplug the power plug (4-wire),
and the meter plug (3-wire) on the lower right side of the
board, then the motor plug on the lower left side of the
board. Carefully lift up slightly the tab holding the circuit
board in place, then gently pull the board forward, then
lift the board out.
Drive bracket
locking tabs
2.
Next, remove the drive bracket by gently lifting the two
tabs securing the the bracket and tilt it forward from the
tabs. The lower edge of the drive bracket has two notches
that rest on the drive back plate. Lift up and outward on
the drive bracket to disengage the notches.
3.
Then, remove the power supply wire and transformer by
pushing/pulling it through the slot in the backplate.
Set the power supply and cord aside as it will not be
used in this application.
Copyright ©2021 Aqua Systems, All Rights Reserved • 404 Moravian Valley Road, Waunakee, WI 53597
3
Install & Service Guide
Manual Supplement
Advertisement
Table of Contents
