Panasonic BL-C30 Installation Manual page 28

Troubleshooting
Problem
Image is out of • The lens has dust, dirt, fingerprints or droplets on it.
focus.
• The object is too close to the camera.
The color on the • White balance does not work well.
image is
strange.
• The color display setting on your PC is set lower than 16 bits.
Image flickers. • The object is dark.
• The AC power source frequency setting is wrong.
• A bright object may cause horizontal flickers on the image.
An old image is • The old image is temporarily stored on the web browser.
displayed.
All manuals and user guides at all-guides.com
Cause and Remedy
Clean the lens with a cotton bud (see page 102 of the
Operating Instructions on the Setup CD-ROM).
The camera cannot focus at short distances
(less than 0.5 m). Locate the object more than 0.5 m away
from the camera.
Adjust the white balance on the Camera page (see page 45
of the Operating Instructions on the Setup CD-ROM).
Set the color display 16 bits or higher.
Make the area around the camera brighter.
Set the proper AC power source frequency used in your area
(see page 45 of the Operating Instructions on the Setup CD-
ROM).
Changing the object improves the flickers. Or adjusting
brightness to the [+] side on the operation bar eases the
flickers.
Set [Every visit to the page] on the web browser to check for
temporary Internet files (see page 110 of the Operating
Instructions on the Setup CD-ROM).
Installation/Troubleshooting
28