Panasonic BL-C30 Installation Manual page 20

Troubleshooting
Problem
Indicator • Automatic setup is not complete.
continues
blinking green.
• The camera did not get its IP address from the DHCP server.
Indicator does • Indicator display is disabled.
not light up.
• Confirm that the standard AC adaptor PQLV202 (Order No.
PQLV202X) is being used.
Indicator • The camera may be malfunctioning.
continues
blinking red.
Indicator lights • The camera is in privacy mode.
red.
Indicator • Only the MAC addresses for the camera's wireless module are
continues set.
blinking orange
during the
wireless
communication.
All manuals and user guides at all-guides.com
Cause and Remedy
Complete the setup following Getting Started.
When setting [Automatic Setup] or [DHCP Setup], the
camera may not get its IP address due to network failures.
Ask your ISP or network administrator for more information.
Check if the indicator control is disabled (see page 80 of the
Operating Instructions on the Setup CD-ROM).
If you cannot access the camera, the camera may be
malfunctioning. Call our customer call center.
To disable the privacy mode, press the privacy button (see
page 8) on the front of the camera or click [Disable]
accessing and logging in to the camera as an administrator.
To enable the MAC address filtering feature on the wireless
router, enter both the MAC addresses for the camera itself
and the camera's wireless module.
Installation/Troubleshooting
20