MASSEY FERGUSON 6400 Workshop Service Manual page 128

Perkins/GTA2520 engine separation
B . Disassembling and reassembling
(six-cylinder Perkins engine)
Implementation
1. Apply the handbrake.
2. Check that the suspended front axle (if fitted) is in
low position and unscrew the control unit bleed
screw (see chapter 9).
3. Remove the lateral panels from each side of the
engine and bonnet (if necessary).
Operations underneath the tractor
4. Dismantle the front linkage reinforcements (if
mounted).
5. Remove the guard and the shafts (4 WD tractors).
Operations at the front of the tractor
6. Remove the front weights (if fitted).
Operations on the right-hand side of the
tractor
7. Remove the footplate.
8. Disconnect and remove the batteries then the
support.
9. Disconnect the flexible sleeve (1)
the suction port. Remove the vertical exhaust
assembly (including support
10. Mark then disconnect:
- the cables (positive and negative) on the starter
- the front differential lock hose
- the hose on the steering ram
- the lubricating hoses (running to and from the
cooler) (Fig.
2B11.4
¤
H
(Fig. 1) fitted to
Fig. 2).
3)
Fig. 1
Fig. 2
Massey Ferguson 6400 - Issue 4.a