Advertisement
Ubee Interactive — www.ubeeinteractive.com
parameters are reset to factory defaults. Refer
to the User Guide for more information.
2. WPS button (top of device): The WPS button
is used for the Wi-Fi Protected Setup (WPS)
method to connect a Wi-Fi device to the
DEVICE. Refer to the User Manual for more
information.
LEDs and Other Device Indicators
See the following diagram and descriptions of the
device's LED behavior, and the behavior of the
back-panel Ethernet indicators
5
Ubee DDW36C – Safety and Installation Product Insert v1.0
Power—If On, indicates that the device has
successfully completed internal power-on tests.
LED flashes if power-on fails. Note that the LED
flashes briefly immediately after powering the
device.
DS—When the DS locks on to channels, the LED
is On. When the DS SCAN IN PROGRESS, the
LED flashes.
US—When the US locks on to channels, the LED
is On. When the US SCAN IN PROGRESS, the
LED flashes.
ONLINE—When the device is obtaining an IP
address and configuration file, the LED flashes.
When device obtains these items, the LED is On.
2.4G Wi-Fi—When 2.4G Wi-Fi is enabled, the
LED is On. When 2.4G Wi-Fi is disabled, the
LED is Off. When passing 2.4G Wi-Fi network
traffic, the LED flashes.
5G Wi-Fi—When 5G Wi-Fi is enabled, the LED is
On. When 5G Wi-Fi is disabled, the LED is Off.
When passing 5G Wi-Fi network traffic, the LED
Advertisement
