Advertisement
UNPACKING &
CHECKING CONTENTS
UNPACKING AND CHECKING
CONTENTS
WARNING: IF ANY PARTS ARE MISSING
OR BROKEN, GET THE PROPER PARTS
REPLACED BEFORE ASSEMBLY OR USE
OF THIS DUST COLLECTOR.
Remove entire contents of carton. Check
each item against the loose parts list.
Notify
your
KING CANADA
retailer
immediately if any parts are damaged or
missing.
This dust collector is intended for either
commercial or for household use.
LOOSE PARTS LIST
1) Motor and housing impeller ............1
2) Adaptor (8")-4 (4") ............................1
3) Housing............................................2
4) Leg support......................................2
5) Support bracket ..............................2
6) Upper hanger ..................................2
7) Lower hanger ..................................2
8) Base ................................................1
9) Lower dust bag ................................2
10) Hardware bag ................................1
11) Retainer strap (bag) ......................4
12) Caster (bag) ..................................4
13) Manual ..........................................1
14) Upper dust bag ..............................2
MOUNTING THE PIVOTING CASTORS TO
THE BASE
Place the base upside down and fix the 4
castors using lock washers and hex. nuts.
See Fig.1.
MOUNTING THE SUPPORT BRACKETS
TO THE BASE
Mount one support bracket at a time to the
base using hex. bolts and washers. See
Fig. 2. NOTE: Once this assembly is
done, note that the support bracket with
the welded switch bracket is now the front
of the dust collector.
MOUNTING THE SUPPORT LEGS TO
THE BASE
Mount one support leg one at a time to the
base using hex. bolts and washers. See
Fig. 3.
ASSEMBLY INSTRUCTIONS
Figure 1
Figure 2
Hex. bolt
Washer
Figure 3
Hex. nut
Lock
washer
Hex. bolt
Washer
Advertisement
