Names And Functions Of Parts; Front And Document Feed And Eject Trays - Canon SCANFRONT 300 Instructions Manual

3.

Names and Functions of Parts

The names and functions of the parts of the ScanFront 300/300P are shown below.
❏ Front and Document Feed and Eject Trays
a Tray Extension
Open this to prevent scanned documents from slipping off.
b Document Eject Tray
Open this tray when using the ScanFront. If scanned
documents curl in the document eject tray, remove the
entire tray. (See p. 2-4.)
c Panel Unit
Open this when there is a paper jam or to perform
maintenance. (See p. 2-10.)
d Touch Panel
Touch this screen to operate the ScanFront.
e Lock Lever
Locks the panel unit. Pull the lever toward you to unlock
the panel unit. (See p. 2-10.)
f Document Guides
Adjust these to match the width of the document.
p. 2-6.)
g Document Feed Tray
Place documents here.
h USB Port (Front)
Connect a USB1.1/Hi-Speed USB2.0 compatible USB
memory device, USB keyboard, or USB mouse.
i Power Switch
Use this to turn the power ON.
* Use the Power OFF button on the touch panel to turn the
power OFF.
j Feed Selection Lever
Use this lever to change the feed method for documents.
(See p. 2-5.)
k Power Indicator
Lights when the power is ON.
l Fingerprint Authentication Sensor (Only Available
with the ScanFront 300P)
This fingerprint sensor is for fingerprint registration and
authentication. (See p. 2-11.)
1-8
Chapter 1 Before Use
(See
(See p. 2-4.)
(See p. 3-4.)
(See p. 3-4.)