Table of Contents
Advertisement
All manuals and user guides at all-guides.com
27
Tape Deck Operation
Recording or playback cannot be
made or there is a decrease in
audio level.
• Dirty tape heads, capstans or
pressure rollers.
™ See section on tape deck maintenance
(page 26).
• Magnetic build-up in the record/
playback head.
™ Use demagnetizing tape.
Tape deck door cannot open.
• Power failure or AC power plug
disconnect from the wall outlet
during tape playback.
™ Reconnect the AC power plug and
switch on the system again.
General
System does not react when any
button is pressed.
• Electrostatic discharge
™ Press STANDBY ON to switch the
system off. Remove the AC power plug
from the wall outlet, then reconnect
the power plug and switch on the
system again.
pg 01-28/C85/37-Eng
27
TROUBLESHOOTING
No or poor sound.
™ Reduce the distance.
• Volume is not turned up.
• Batteries are inserted incorrectly.
™ Adjust VOLUME.
™ Insert the batteries with their polarities
• The headphones are connected.
(+/– signs) as indicated.
™ Disconnect the headphones.
• Batteries are exhausted.
• Speakers are not connected or are
™ Replace the batteries.
connected wrongly.
Timer is not working.
™ Check that the speakers are
• Clock is not set.
connected correctly.
™ Set the clock.
™ Make sure the stripped speaker wire is
• Timer is not switched on.
clamped.
™ Press TIMER ON/OFF to switch on the
Reversed left and right sound.
timer.
• Speakers are connected wrongly.
• Recording is in progress.
™ Check the speaker connections and
™ Stop recording.
location.
Clock setting is erased.
Lack of bass sound or apparently
• There was a power failure.
imprecise physical location of
™ Reset the clock.
musical instruments.
System displays features
• Speakers are connected wrongly.
automatically; buttons flash
™ Check the speaker connection for
continuously.
proper phasing, colored/black wires to
• Demonstration mode is switched
colored/black terminals.
on.
™ Press and hold Ç (on the system) for
Remote control has no effect on
the system.
five seconds to switch off the
• Wrong source is selected.
demonstration.
™ Select the source (CD, TUNER, etc.)
There is a howling sound at the
before pressing the function button
external source.
( É , í , ë , etc.).
• You hear feedback when you are
• The distance to the system is too
listening in AUX mode
large.
™ Press AUX to select CDR/DVD mode.
All lighted buttons are not lit.
• Display is switch on in DIM 3 mode.
™ Press DIM until DIM OFF display
mode is shown.
3139 116 19591 (ENG)
2/16/00, 9:03 AM
Advertisement
Table of Contents
