Setup Procedures; Quick Setup List - Briggs & Stratton Simplicity Champion Zero-Turn Rider Adjustment Instructions Manual

Simplicity / Massey Ferguson / Snapper ZTR

Quick Setup List

Page Setup Procedure
3 Uncrating
3 Battery Activation &
Installation
4 Rider Assembly
5 Check Fluid Levels
7 Mower Assembly
7 Lubrication
8 SAFETY CHECKS
8 Burnish Electric Clutch
Register Product
Steps to Perform
o Remove crate & banding.
o Place transmissions in PUSH position & roll off skid.
o Charge the battery (Note: proceed with other setup steps
while battery is charging).
o Test battery with hydrometer or load-tester.
o Install & secure battery.
o Install the seat and connect the seat switch
o Install ground speed control levers.
o Fill & check Engine oil level.
o Check transmission fluid level.
o Reduce & check tire pressures
(Front tires 40 psi, rear tires 15 psi).
o Torque mower blade bolts.
o Lubricate all grease & oil points.
o Check for LOOSE HARDWARE.
o Check all OPERATOR CONTROLS.
o Test PARKING BRAKE.
o Perform MOWER BLADE STOPPING CHECK.
(Blade must stop within 5 seconds!)
o Perform SAFETy INTERLOCK SySTEM CHECK.
o Burnish electric clutch (run for 15 seconds, repeat 10 times).
o Repeat MOWER BLADE STOPPING CHECK.
(Blade must stop within 5 seconds!)
o To register the product: log onto www.thepowerportal.com,
select the appropriate brand, click "My Resources," select
the "Product Registration and Rebate" icon and then the
"New Product Registration / Rebate" tab. Fill out and sub-
mit the online product registration form.
2