RedMax EBZ8560 Workshop Manual page 30

9. Remove the muffler. Refer to
the muffler on page 15 .
10. Remove the 4 screws and the engine.
11. Install in the opposite sequence.
12. Do a pressure test. Refer to
engine on page 28 .
7.11.2 To disassemble the crankcase
1. Remove the spark plug cap and the cylinder cover.
To remove and install the cylinder cover on
Refer to
page 13 .
2. Remove the starter unit. Refer to
install the starter unit on page 13 .
3. Remove the flywheel. Refer to
the flywheel on page 24 .
4. Remove the muffler. Refer to
the muffler on page 15 .
5. Remove the carburetor. Refer to
install the carburetor on page 19 .
6. Remove the frame. Refer to
the frame on page 34 .
7. Remove the fan. Refer to
fan on page 37 .
8. Remove the engine. Refer to
the engine on page 29 .
9. Remove the cylinder and piston. Refer to
and install the cylinder and piston on page 25 .
30 - Repair instructions
To remove and install
To do a leak test of the
To remove and
To remove and install
To remove and install
To remove and
To remove and install
To remove and install the
To remove and install
To remove
10. Remove the 4 screws.
11. Push a flat screwdriver into the 2 notches on the
crankcase and remove the flywheel side of the
crankcase.
12. Use a press tool to push out the crankshaft from the
fan side of the crankcase.
13. Use a screwdriver or equivalent to remove the seal
ring from the crankcase halves.
14. Use a press tool to push out the bearings from the
crankcase halves.
15. Examine the oil seals and the bearings. Replace
parts that show signs of wear.
1662 - 003 - 04.11.2021