RedMax EBZ8560 Workshop Manual page 14

6. Remove the screw (A) and the washer (B).
A
B
C
D
E
F
G
7. Remove the puller (C) and the spring (D).
8. Remove the washer (E) and the pulley (F).
9. Carefully remove the recoil spring (G) from the
starter housing.
WARNING: Be very careful when you
remove the starter pulley. The recoil spring
can eject and cause injury.
10. Assemble in the opposite sequence.
Note: Apply grease to washer (B), spring (H) and
axle (I).
7.4.3 To replace the starter pawls
1. Remove the cylinder cover. Refer to
install the cylinder cover on page 13 .
2. Remove the starter unit. Refer to
the starter on page 13 .
3. Remove the flywheel. Refer to
the flywheel on page 24 .
14 - Repair instructions
H
I
To remove and
To disassemble
To remove and install
4. Remove the 2 snap rings.
5. Remove the 2 starter pawls.
6. Install in the opposite sequence.
1662 - 003 - 04.11.2021