Assembly - NordicTrack SpaceSaver Plus User Manual

ASSEMBLY

Assembly requires two persons. Place all parts of the elliptical exerciser in a cleared area and remove the
packing materials. Do not dispose of the packing materials until assembly is completed.
Assembly requires the included tools and your own Phillips screwdriver
wrench , and rubber mallet
As you assemble the elliptical exerciser, use the drawings below to identify small parts. The number in parenthe-
ses below each drawing is the key number of the part, from the PART LIST near the end of this manual. The
number following the parentheses is the quantity needed for assembly. Note: Some small parts may have
been preassembled. If a part is not in the hardware kit, check to see if it has been preassembled.
Wave Washer
(80)–2 Washer (97)–16
M10 Split
Washer (99)–4
M6 x 32mm Patch
Screw (113)–4
M8 x 45mm Patch Screw (90)–6
M8 Split
M8 Washer
(106)–2
Large Wave
Washer (89)–2
Locknut (94)–2
M8 x 14mm Patch
Screw (84)–6
M10 x 80mm Patch Screw (93)–4
.
M8 x 23mm
Thin Washer
(96)–2
M4 x 16mm
M8 Nylon
Round Head
Screw (92)–23
M8 x 19mm Patch
Screw (86)–6
M10 x 58mm Shoulder Bolt (104)–2
5
, adjustable
M8 x 23mm
Washer (31)–10
M4 x 16mm
Blunt Screw
(33)–5
M8 x 23mm Shoulder
Patch Screw (105)–2