Table of Contents
Advertisement
ASSEMBLY
• Assembly requires two persons.
• Place all parts in a cleared area and remove the
packing materials. Do not dispose of the packing
materials until you finish all assembly steps.
• Left parts are marked "L" or "Left" and right parts
are marked "R" or "Right."
• To identify small parts, see page 5.
1. Go to www.iconsupport.eu on your computer
and register your product.
• activates your warranty
• saves you time if you ever need to contact
Customer Service
• allows us to notify you of upgrades and offers
Note: If you do not have internet access, call
Customer Service (see the front cover of this
manual) and register your product.
2. Have a second person raise the Upright (2) and
hold it in the position shown.
Slide the Right and Left Upright Covers (60, 96)
upward as shown.
Secure the Upright (2) to the Frame (1) with four
M8 x 20mm Screws (61); do not tighten the
Screws yet.
• In addition to the included tool(s), assembly
requires the following tools:
one Phillips screwdriver
one rubber mallet
one adjustable wrench
Assembly may be easier if you have a set of
wrenches. To avoid damaging parts, do not use
power tools.
1
2
60, 96
61
73, 75
6
Avoid pinching
the wires
2
61
1
Advertisement
Table of Contents
