3. Using the joystick, scroll over to Device Access to view the page below. Using the joystick, select Furuno
and press the Enter button
Enter
button
You will lose connection with the Omnisense Controller, this will be fixed in the next step.
On the TZtouch3:
4. Navigate to [Home] > [Settings] > [Camera]
5. Scroll down to Analog Video 1 and toggle "Connected" to "OFF"
6. Scroll down to "IP Camera 1" section
7. Tap the Keyboard beside IP Camera 1
8. Type in the following IP address: 172.031.201.200
9. Exit out of the TZtouch3 Menu by tapping the X in the upper right corner of the TZT3 screen.
10. You can now disconnect the analog video cable from TZtouch3 Video-In 1
,then use the joystick to highlight Save and Reboot, then press the
.Choose "OK" when prompted to continue. Allow the camera system time to reboot.
Power off your TZT3 and the power it back on again.
5