Getting Started; Omnisense Camera Setup - Furuno NavNet TZtouch3 TZT2BB Setup Manual

4. Getting Started

Notes:
Prior to powering up the Omnisense camera, please ensure it is securely mounted as the
•
camera will move during its boot up sequence.
If at any time during the camera setup you are prompted for a Login and Password, Login is Admin and
•
the Password is 1 2 3 4 5
1. Power ON the Omnisense Junction Box and TZtouch3 unit and wait for the camera, controller and MFD to
initialize.
2. Navigate to [Home] > [Settings] > [Camera] on the TZtouch3 MFD
3. Once inside the Camera menu, scroll down to Analog Camera 1 and select "ON" for "Connected"
4. You should now see the analog video input of the Omnisense camera on the right side of the TZT3 screen. Tap
on the X in the upper right-hand corner of the TZT3 screen to exit.
5. Tap [Home]
6. Tap the Camera Icon to navigate to the camera page to view the full-screen camera mode.
7. Use the controller and pan around the area to see that the camera is fully functioning prior to proceeding and
confirm this by watching the video on the TZT3 screen.

5. Omnisense Camera Setup

1. Press the Menu button
screen.
2. Using the joystick, scroll down to the Settings Icon
on the Omnisense Controller. The menu will show up on the right side of the TZT3
and press Enter on the controller.
4