Is911 Module Registration And Parameter Setting - Toshiba nv Series Instruction Manual

Tc-net i/o serial communication module is911

Hide thumbs Also See for nv Series:

Table of Contents

Chapter 3 Setting

3.2

IS911 module registration and Parameter setting

The engineering tool is used to register and configure the IS911 module.

The registration and setting method is explained below.

Based on the system configuration example shown below, the IS911 registration

method with the system name "IS911 system" and the parameter setting method

are explained.

Ethernet

TC-net I/O Loop

TC-net I/O Bus

6F8C1509

Remark

 In this explanation, [ . . . ] represents components, etc. ( . . . ) represents dialogs,

< . . . > represents menus, etc. " . . . " represents input or selection, etc.

 Refer to "Unified Controller nv series/Integrated Controller V series Engineering Tool 4

(Basic) Instruction Manual" (6F8C1290) for how to operate the engineering tool.

STA (nv station)

00(BU825)

TC-net I/O input and output

Serial Transfer Data R/W

Figure 3-2 System configuration (example) for Registration and setting

OIS-DS

IS911 system registration /

00 02

SA911

IS911

RS-485

SYSMAC PLC-1

Station No.=01

Station No.=02

of IS911 module

setting range

Table of Contents