Toshiba nv Series Instruction Manual page 18

Chapter 1 Introducing the IS911 Module
Rotary setting switch (I/O, STN-H, STN-L)
For setting method, refer to "Chapter 3 - 3.1 Switch Setting "
Operation mode setting switch (MODE)
Used when removing a module. Refer to "Chapter 2 - 2.3 Replacing IS911
Module" and "Chapter 3 - 3.1 Switch Settings" for usage. Normally, set all to
OFF.
Maintenance switch (MAINT)
Switches to install or replace modules.
Refer to "Chapter 2 - 2.3 Replacing IS911 Module" and "Chapter 3 - 3.1 Switch
Settings" for usage.
Maintenance communication port (TOOL)
A port for maintenance. It cannot be used by the user.
RS-232C I/F connector
RS-232C communication connector.
Refer to "Chapter 2 - 2.4 Transmission cable connection" to connect the
RS-232C transmission cable.
RS-485 I/F connector
RS-485 / RS-422 communication connector.
Refer to "Chapter 2 - 2.4 Transmission cable connection" to connect the
RS-485 / RS-422 transmission cable.
6
6F8C1509
SW Name
Used to set the TC-net I/O bus address.
I/O
This setting is not used.
STN-H
STN-L
SW Name
MAINT Please select before removing the IS911 module.
RUN Please select after installing the IS911 module.
Setting details
Setting details