Advertisement
IM 701989-01E
• Do not use the probe near flammable gases.
To avoid injury and fire, do not use the probe near flammable or
explosive gasses or vapors.
• Avoid exposed circuits.
To prevent injury, when the power is ON, do not touch any exposed
contact points or components.
• Be sure to use the accessory probe lead set when connecting to the
circuit under test.
• The instrument's GND lead is of the same electric potential as the
grounding of the connected oscilloscope.
• This is a precision-manufactured instrument. Damage can occur as a
result of sudden changes in ambient temperature or physical shocks.
Handle with care.
• To prevent trouble such as breakages or contact failures, please note
the following when handling the cable connected to the instrument.
• Do not apply force to the connectors.
• Never bend the cable to a radius of less than 60 mm.
• Never apply force to a small part of the cable, nor deform the cable.
• Never twist or pull the probe leads or GND lead any more than
necessary. The wires inside the leads can break, causing malfunction.
• Avoid vibration, shock, and static electricity when transporting or
handling the instrument. Especially take care not to shock the instrument
such as by dropping it.
• Avoid storing or using the probe in direct sunlight, or areas that have
high heat, humidity, or condensation. The probe can become deformed
or its insulation can deteriorate, resulting in the probe failing to meet its
specifications.
• Before use, inspect and check the operation of the probe to confirm that
no problems have been caused by harsh storage or transport conditions.
If problems are found, please contact your nearest Yokogawa dealer or
representative.
• This instrument is not drip- or dust-proof. Do not use in areas where it
may come into contact with water or a large amount of dust.
CAUTION
v
Advertisement
