Advertisement
IM 701989-01E
General Specifications
Standard operating
conditions
Operating
environment
Storage environment Temperature
Interface and power supply
Calibration cycle
Warm-up time
Ext. dimensions (main body)
Total length
Weight
4. No condensation
Standards Compliance
EMC
Emissions
standards
Immunity
Environmental
standards
6
5. Test conditions
Connected to the DLM2000 series mixed signal oscilloscope, with the logic probe's
lead set terminated at 50 Ω.
Cable condition
Attach a ferrite core (TDK: ZCAT2035-0930A, YOKOGAWA part number:
A1190MN) to both ends of the cable (see figure below).
6 For conformity to environmental regulations and/or standards other than EU,
contact your nearest YOKOGAWA office (PIM113-01Z2).
Temperature
23±5°C
4
Humidity
55 ±10% RH
Temperature
5 to 40°C
4
Humidity
20 to 80% RH
Altitude
2000 m or less
−20 to 60°C
Humidity
4
20 to 80% RH
Altitude
3000 m or less
Dedicated logic probe interface
Power supplied from a dedicated logic probe
interface
1 year
30 minutes or more
94.5 mm × 40 mm × 15 mm
Approximately 1.7 m
Approximately 200 g (excluding accessories)
Conforming standards
EN61326-1 ClassA
EN55011 Class A Group1
EMC standards of Australia and New Zealand EN55011
Class A, Group1
Korea Electromagnetic Conformity Standard ( 한국
전자파적합성기준 )
This is a Class A product. Operation of this product in a
residential area may cause electromagnetic interference
in which case the user will be required to correct the
interference.
Conforming standard
EN61326-1 Table 2 (for use in industrial locations)
Influence in the immunity testing environment
The logic probe's polarity must not reverse
EU RoHS Directive compliant
5
9
Advertisement
