Power Steering Unit Installation - Polaris RZR XP 1000 2014 Service Manual

POWER STEERING UNIT INSTALLATION

1. If the power steering unit
w
mount bracket , reinstall it prior to vehicle
installation. Torque the mounting bolts
lbs. (27–33 Nm)
2. Install the power steering unit into the vehicle and
align the skip-tooth spline on the power steering stub
shaft with the opening in the lower steering shaft.
3. Place the power steering mount bracket over the top
of the brake pedal mount studs and finger tighten the
four nuts.
4. Position the lower steering shaft on the power
steering unit stub shaft and install the pinch bolt.
Torque to specification.
TORQUE
Lower Steering Shaft to EPS Unit Pinch Bolt:
15 ft-lbs (20 Nm)
9926816 R07 - 2014-2016 RZR XP 1000 / XP4 1000 Service Manual
© Copyright Polaris Industries Inc.
q
was removed from the
e
to 20–24 ft.
STEERING / SUSPENSION
5. Torque the four mount
specification.
TORQUE
Power Steering Unit Mount Bracket Nuts:
16 ft-lb (22 Nm)
6. Proceed to Upper Steering Shaft Installation, page
8.10 to complete the installation procedure.
y
bracket nuts to
8
8.9