Brake Hose And Fitting Inspection; Parking Brake Cable Adjustment (Intl); Parking Brake Pad Inspection (Intl) - Polaris RZR 570 2013 Service Manual

BRAKE HOSE AND FITTING INSPECTION

Check brake system hoses and fittings for cracks,
deterioration, abrasion, and leaks. Tighten any loose
fittings and replace any worn or damaged parts.
PARKING BRAKE CABLE ADJUSTMENT
(INTL)
When the parking brake is fully engaged and "BRAKE" is
displayed on the instrument cluster, engine speed is
limited to 1500 RPM while in gear. If throttle is applied,
this limiting feature prevents operation, which protects
the parking brake pads from excessive wear.
NOTE
Inspect the parking brake cable tension after the first 25
hours of operation and every 100 hours of operation
afterwards to ensure proper cable tension.
Loss of tension in the parking brake cable will cause
illumination of the parking brake indicator and activation
of the limiting feature. If this occurs, inspect and adjust
parking brake cable tension. If performing this service is
difficult due to conditions or location, temporarily
disconnect the parking brake switch electrical connector.
Reconnect the connector as soon as practicable and
adjust the parking brake cable to proper tension.
1. Pull back on the parking brake lever (located in
dash).
2. After 3 to 4 clicks "BRAKE" should display on the
instrument cluster and the wheels of the vehicle
should not rotate when turning by hand. After 8 full
clicks of lever travel, the vehicle should not roll while
parked.
3. If the vehicle moves, adjustment is necessary.
4. Adjust the parking brake cable where the cable
attaches to the caliper mount / shift cable bracket.
The mount bracket is located on the right-hand side
of the transmission.
Adjustment Procedure: Refer to Chapter 9
"Brakes" for complete adjustment procedure.
9926813 R04 - 2013-2016 RZR 570 Service Manual
© Copyright Polaris Industries Inc.

PARKING BRAKE PAD INSPECTION (INTL)

Inspect the parking brake caliper brake pad thickness.
Replace brake pads if damaged or worn beyond service
limit. Replace caliper assembly if damage or excessive
wear is found. Refer to the following image for brake pad
specifications.
MAINTENANCE
2
2.33