Polaris RZR 570 2013 Service Manual page 267

13. Slowly rotate the snorkel tube clockwise while
counting the number of notches passing through the
hole opening as you rotate the tube. Rotate the
snorkel tube to the 3rd notch from the 'zero'
backlash position obtained in step 11.
14. Check the pinion shaft gear backlash again by feel. If
the pinion shaft gear lash appears to be too tight,
rotate the snorkel shaft clockwise to the next notch
(4th notch).
15. Once the backlash is set, apply Loctite
threads and install the locking screw to secure the
snorkel tube.
9926813 R04 - 2013-2016 RZR 570 Service Manual
© Copyright Polaris Industries Inc.
16. Torque the locking screw to specification.
Transmission Assembly
® 242 ™ to the
The snorkel shaft and pinion shaft must be installed
prior to transmission assembly. The snorkel shaft
cannot be installed after assembling the transmission.
17. Clean both transmission case halves thoroughly.
Inspect case half mating surfaces for damage.
TRANSMISSION
TORQUE
Snorkel Locking Screw:
8 ft-lbs (11 Nm)
NOTE
6
6.23