Polaris RZR 570 2013 Service Manual page 271

30. Install the spacer onto the shift drum shaft.
31. Install the detent star onto the shift drum shaft. Be
sure to install the detent star with the raised edge
facing outward and skip-tooth aligned.
32. Install the detent pawl onto the shift shaft and
carefully install the compression spring.
9926813 R04 - 2013-2016 RZR 570 Service Manual
© Copyright Polaris Industries Inc.
33. Install a new O-ring on each shift shaft. Apply a small
amount of white lithium grease on the O-rings, shift
shafts and component contact surfaces prior to
installing the sector cover.
34. Clean the transmission and gear sector cover mating
surfaces thoroughly.
35. Apply Crankcase Sealant (3-Bond) (PN 2871557)
onto the cover and transmission case mating
surface.
36. Install the sector cover and align the transmission
case dowel with the alignment hole. Install and
torque the bolts to specification.
TORQUE
Sector Cover Bolts:
11 ft-lbs (15 Nm)
37. Install the transmission drain plug and torque to
specification.
TORQUE
Fill / Drain Plug:
12 ft-lbs (16 Nm)
38. Install the bell Crank onto the shift shaft. Note the
key splined on the bell Crank and shift shaft. Install
the nut and torque to specification.
TORQUE
Bell Crank Nut:
15 ft-lbs (20 Nm)
39. Refer to Chapter 8 – Transmission Installation, page
6.10to complete the repair.
TRANSMISSION
6
6.27