Engine Installation - Polaris RZR 570 2013 Service Manual

29. Remove the four bolts and nuts (M) securing the
engine to the front motor mount bracket.
30. Remove the eight bolts (N) securing the coupler
brackets to the engine and transmission.
31. Loosen the two bolts and nuts (O) so the engine
mount bracket can be slightly tilted away from
engine.
32. With the help of an assistant and the engine hoist,
raise the engine vertically out of the vehicle frame.
NOTE
Have an assistant help guide the engine in and out of
the vehicle while using an engine hoist to prevent
personal injury or damage to the vehicle components.
33. Install the engine stand adapter onto the engine PTO
side mounting ears as shown below.
Engine Stand Adapter
PU-50824
9926813 R04 - 2013-2016 RZR 570 Service Manual
© Copyright Polaris Industries Inc.
ENGINE / COOLING SYSTEM
34. Select the proper engine stand sleeve adapter and
install it onto the engine stand adapter.
Sleeve adapter for a 2" bore engine stand:
PU-50625
Sleeve adapter for a 2.375" bore engine stand:
PW-47054
35. Place engine onto the engine stand for service.
Engine Stand
PU- 50624

ENGINE INSTALLATION

Use the following procedure to reinstall the engine
assembly.
1. Attach engine with suitable lifting straps to an
overhead or portable engine hoist.
2. Remove the engine stand adapter plate.
3. Use the overhead or portable engine hoist and
suitable engine straps to lower the engine into the
vehicle frame.
NOTE
Have an assistant help guide the engine in and out of
the vehicle while using an engine hoist to prevent
personal injury or damage to vehicle components.
4. By hand, install the four front engine mount bolts and
nuts (A). Do not tighten at this time.
5. Instal the four engine to transmission coupler plates
(B) and instal the eight bolts and washers (C). Do not
tighten fasteners at this time.
NOTE
DO NOT torque fasteners at this time.
3
3.33