Cylinder Head Removal; Cylinder Head Disassembly - Polaris RZR 570 2013 Service Manual

ENGINE / COOLING SYSTEM
5. Upon installation, torque all fasteners to specification
and reassemble engine and vehicle as outlined in
this chapter.
TORQUE
Cam Chain Guide Fasteners:
9 ft-lb (12 Nm)
3.42

CYLINDER HEAD REMOVAL

The cylinder head can be serviced with the engine
installed in the chassis.
Do not rotate head assembly up side-down until the
valve tappets have been removed.
1. Remove and discard the two outer M6 bolts
retain the cylinder head
2. Loosen the four cylinder head bolts
turn (60 degrees) at a time until all are loose.
3. Remove and discard the cylinder head bolts
Replace with new upon assembly.
4. Tap cylinder head lightly with a soft faced hammer
until loose. Tap only in reinforced areas or on thick
parts of the cylinder head casting.
5. Remove the cylinder head

CYLINDER HEAD DISASSEMBLY

CAUTION
Wear eye protection during cylinder head disassembly
and reassembly or when working with the valve springs.
9926813 R04 - 2013-2016 RZR 570 Service Manual
NOTE
w
and the cylinder.
e
evenly 1/8
w
and head gasket
© Copyright Polaris Industries Inc.
q
that
e
.
r
.