Auger Gearcase Replacement; Remove Gearcase Assembly - Ariens Sno-Thro Deluxe Series Service Manual

AUGER GEARCASE REPLACEMENT

Remove Gearcase Assembly

IMPORTANT: Save all hardware for reinstallation.
1. Stop engine, remove key and wait for all moving parts
to stop and for hot parts to cool.
2. Disconnect spark plug wire.
3. Remove augers. See Remove Auger on page 25.
See Figure 64.
4. Remove hardware retaining support brackets to
gearcase and remove brackets.
5. Remove washers from auger shaft.
Figure 64
See Figure 65.
6. Remove roll pins retaining impeller to impeller shaft
and remove impeller.
IMPORTANT: Use of penetrating oil or heat may be
necessary to remove impeller.
EN – 29
Figure 65