Install Auger - Ariens Sno-Thro Deluxe Series Service Manual

See Figure 57.
12. Remove auger. Use of penetrating oil or heat may be
necessary to remove auger.
IMPORTANT: If rust is present on auger shaft, remove with
sand paper and wipe clean with oil.

Install Auger

IMPORTANT: Ensure auger helix direction matches the
original auger orientation.
1. Reinstall flange bushing and support bushing onto
auger end. See Figure 58.
See Figure 59.
2. Install auger onto auger shaft with auger kickers facing
gearcase.
IMPORTANT: Ensure auger helix direction matches the
original auger orientation.
3. Apply grease to grease zerk.
Figure 57
Figure 58
4. Align holes in auger with holes in auger shaft and
reinstall shear bolt. Torque bolt to 7.9 N•m – 16.5 N•m
(5.8 lb-ft – 12.2 lb-ft). If torque wrench is unavailable,
tighten until bolts no longer spin freely. DO NOT
overtighten.
1. Kicker
5. Reinstall auger assembly into housing and seat
impeller shaft end into ball bearing at housing rear.
See Figure 60.
EN – 27
1
Figure 59
Figure 60