APRILIA RS 660 2020 Manual page 23

The dashboard has an immobilizer system which prevents start-up in case the system
does not identify a key which has been stored before.
The vehicle is delivered to the customer with two pre-programmed keys. The dash-
board accepts a maximum of four keys at the same time: contact an Authorised
Aprilia Dealer to enable these keys or to disable a key that has been lost. Upon vehicle
delivery, approximately ten seconds after the key is set to ON, the instrument cluster
requests a personal five-digit code to be entered.
See the chapter "Advanced functions" for instructions on modifying the personal code.
When the code is requested, a value (from 0 to 9) is shown for the first figure of the
02_05
code. Use the MODE navigation buttons to modify the value. Press MODE SET briefly
to confirm the value entered for the first figure of the code, and repeat the procedure
to enter the remaining four figures of the code.
It is important to remember the personal code because:
•
the vehicle can be started if the immobilizer system is faulty
•
the dashboard need not be replaced should the ignition switch be
changed
•
new keys can be programmed
NOTE
IF THE PERSONA CODE IS NOT MEMORISED AND THE VEHICLE IS USED, THE
MESSAGE DISAPPEARS AFTER 10 SECONDS BUT REAPPEARS WITH EACH
KEY ON.
NOTE
THE FACTORY SET CODE IS COMPOSED OF FIVE ZEROES.
23