Drive Shaft; Front Drive Shaft Removal - Polaris RZR PRO XP 2020 Service Manual

DRIVE SHAFT

FRONT DRIVE SHAFT REMOVAL

1. Elevate front of vehicle and safely support machine
under the frame area.
CAUTION
Serious injury may result if machine tips or falls. Be
sure machine is secure before beginning this service
procedure. Wear eye protection when removing
bearings and seals.
2. Remove the four wheels nuts and remove the front
wheel.
q
3. Remove the cotter pin and loosen the front wheel
w
hub castle nut . Remove the nut, and cone washer
e
from the front wheel hub assembly. Discard cotter
pin, castle nut, and cone washer.
4. Remove and discard the two front brake caliper
mounting bolts and remove the caliper from the brake
disc. Refer to Front Brake Caliper Removal page
in the Brake System chapter.
CAUTION
Do not hang the caliper by the brake line. Use wire to
hang caliper to prevent damage to the brake line.
5. Remove the front wheel hub assembly.
9850068 R01 - 2020-2021 RZR PRO XP / XP 4 Service Manual
© Copyright Polaris Industries Inc.
6. Remove and discard the upper and lower ball joint
r
pinch bolts and nuts.
7. Using a soft faced hammer, lightly tap on the bearing
carrier while removing the upper the joint end.
8. Remove the drive shaft from the front bearing carrier.
9. With a short, sharp jerk, remove drive shaft from the
front gearcase.
FINAL DRIVE
8
8.11