Front Bearing Replacement - Polaris RZR PRO XP 2020 Service Manual

Hide thumbs Also See for RZR PRO XP 2020:

Table of Contents

FRONT BEARING REPLACEMENT

Bearing Removal

1. Remove inner snap ring

2. Press bearing out using a hydraulic press and

appropriately sized adapter.

3. Inspect the bearing carrier housing for scratches,

wear, or damage. Replace front bearing carrier if

Bearing Installation

1. Thoroughly clean the front bearing carrier housing

and the outer race on the new bearing. Be sure that

all oil and Loctite residue has been removed from

each surface.

2. Support the bottom of the bearing carrier housing

Use an arbor and press only on the outer race,

otherwise bearing damage may occur.

3. Apply Loctite

to the circumference of the new

bearing race

Ensure Loctite is applied around the entire

circumference of the bearing. An acid brush can be

used to assist in even application.

4. Carefully press the new bearing into the bearing

carrier housing.

Use care to not allow any of the Loctite

get in the bearing.

5. Wipe the housing clean of any excess compound and

install the snap ring

6. Allow Loctite to cure for at least 3 hours before

vehicle operation.

9850068 R01 - 2020-2021 RZR PRO XP / XP 4 Service Manual

Table of Contents