Engine Disassembly / Inspection - Bottom End; Stator Cover Removal / Inspection - Polaris RZR PRO XP 2020 Service Manual

ENGINE DISASSEMBLY / INSPECTION - BOTTOM END

STATOR COVER REMOVAL /
INSPECTION
NOTICE
The stator cover can be removed with the engine
installed in the chassis.
1. Remove the thirteen screws
cover.
CAUTION
The flywheel contains powerful magnets. Use caution
when removing and installing the stator cover. DO NOT
place fingers between cover and crankcase at any time
during the removal / installation process or injury could
result.
2. Carefully pry the stator cover off the engine using the
two pry areas as shown below.
9850068 R01 - 2020-2021 RZR PRO XP / XP 4 Service Manual
© Copyright Polaris Industries Inc.
3. Inspect the condition of the stator windings
q
retaining the stator
4. Inspect the ball bearing that supports the starter
5. If bearing
ENGINE / COOLING SYSTEM
w
output wires . If replacement is required, refer to the
Electrical Chapter.
motor shaft.
e
replacement is required, remove the
r
retaining ring and heat the stator cover around the
bearing evenly with a heat gun. Tap cover on a soft
work surface to remove the bearing from the housing.
A blind bearing puller can also be used. Replace
bearing if removed.
q
and
3
3.63