New Holland B80B Service Manual page 39

Engine - Install
If applicable, remove caps and plugs from previously
disconnected hoses and fittings. Remove identification
tags after making the hose and wire connections.
NOTE: The photos in this procedure may be different from
your machine and are for reference only.
1. Position the engine in the machine.
NOTICE: Make sure that the flex plate/converter assembly
stays in place on the transmission.
2. Install and tighten the flat washers and cap screws se-
curing the transmission to the engine.
Tighten cap screws to a torque of 52 – 57 N·m (38
– 42 lb ft).
Install and tighten the front engine mounting bolts, flat
washers, and nuts.
Tighten the self-locking nuts to a torque of 90 –
100 N·m (66 – 74 lb ft).
3. Disconnect the lifting equipment from the lifting eyes on
the engine.
4. Tighten the cap screws through the access in the fly-
wheel housing (1) and fasten the flywheel to the flex
plate. Tighten cap screws to a torque of 52 – 57 N·m
(38 – 42 lb ft) when fixing the torque converter.
5. Install the access cover to the bell housing.
Tighten it to a torque value of 52 – 57 N·m (38 –
42 lb ft).
6. Install the starter onto the engine.
Tighten it to a torque value of 40 N·m (29 lb ft).
Refer to Engine starter - Install (55.201).
Engine - Engine and crankcase
48143704 20/04/2017
10.1 [10.001] / 6
1
PTIL13TLB0729AA
2
PTIL13TLB0730AA
3
PTIL13TLB1470AA