Kohler C3-500 Homeowner's Manual page 11

5. Preparation before the Initial Use
Ensure if water inlet valve is OPEN.
Connect the inlet hose; open the water stop valve and connect the power.
Toilet generates one short beep once it is plugged in. The nozzle stretches
out and draws back once. Backlight on the side panel lights up and the night
light flashes until the initialization process completes.
During initialization, it is normal to hear rotating sound of the motor and bicker.
Wrap seat with plastic sheet to prevent splash water from toilet during test.
The seat is designed not to function without an occupant. To activate the seat
controls for testing purposes, when facing the toilet, place your hand or a damp
wash cloth on the right side of the seat approximately 1/3 from the front of the
seat (sensor area).
Proceed to the "Keypad and Panel Diagram" and "Other Function Introduction"
Sections to test the various seat functions.
The Bidet is set to Factory mode before initial use:
Front/rear/defecation wash:
Water temp: mid
Water pressure: mid/mid/high
Position: mid distance
Kid wash:
Water temp: mid
Water pressure: low
Position: far distance
Kohler Co.
Auto deodorizing: ON
Massage: OFF
Seat temperature: mid
Dryer temperature: mid
Night light: on
Energy saving: off
Auto sanitizing: ON
Prolonged seating indication: OFF
11
1338634-T01-E