New Holland T7030 Service Manual page 9

Do not wear rings, wristwatches, jewels, unbuttoned or flapping clothing such as ties, torn clothes, scarves, open
•
jackets or shirts with open zips which could get caught on moving parts. Use approved safety clothing such as
anti-slipping footwear, gloves, safety goggles, helmets, etc.
Wear safety glasses with side guards when cleaning parts using compressed air.
•
Damaged or frayed wires and chains are unreliable. Do not use them for lifting or towing.
•
Wear suitable protection such as approved eye protection, helmets, special clothing, gloves and footwear when-
•
ever welding. All persons standing in the vicinity of the welding process should wear approved eye protection.
NEVER LOOK AT THE WELDING ARC IF YOUR EYES ARE NOT SUITABLY PROTECTED.
Never carry out any repair on the machine if someone is sitting on the operator's seat, except if they are qualified
•
operators assisting in the operation to be carried out.
Never operate the machine or use attachments from a place other than sitting at the operator's seat or at the side
•
of the machine when operating the fender switches.
Never carry out any operation on the machine when the engine is running, except when specifically indicated. Stop
•
the engine and ensure that all pressure is relieved from hydraulic circuits before removing caps, covers, valves,
etc.
All repair and maintenance operations should be carried out with the greatest care and attention.
•
Disconnect the batteries and label all controls to warn that the tractor is being serviced. Block the machine and all
•
equipment which should be raised.
Never check or fill fuel tanks or batteries, nor use starting liquid if you are smoking or near open flames as such
•
fluids are flammable.
The fuel filling gun should always remain in contact with the filler neck. Maintain this contact until the fuel stops
•
flowing into the tank to avoid possible sparks due to static electricity build-up.
To transfer a failed tractor, use a trailer or a low loading platform trolley if available.
•
To load and unload the machine from the transportation means, select a flat area providing a firm support to the
•
trailer or truck wheels. Firmly tie the machine to the truck or trailer platform and block wheels as required by the
transporter.
Always use lifting equipment of appropriate capacity to lift or move heavy components.
•
Chains should always be safely fastened. Ensure that fastening device is strong enough to hold the load foreseen.
•
No persons should stand near the fastening point.
The working area should be always kept CLEAN and DRY. Immediately clean any spillage of water or oil.
•
Never use gasoline, diesel oil or other flammable liquids as cleaning agents. Use non-flammable non-toxic pro-
•
prietary solvents.
Do not pile up grease or oil soaked rags, as they constitute a great fire hazard. Always place them into a metal
•
container.
START UP
Never run the engine in confined spaces which are not equipped with adequate ventilation for exhaust gas extrac-
•
tion.
Never bring your head, body, arms, legs, feet, hands, fingers near fans or rotating belts.
•
ENGINE
Always loosen the radiator cap very slowly before removing it to allow pressure in the system to dissipate. Coolant
•
should be topped up only when the engine is stopped.
Do not fill up fuel tank when the engine is running.
•
Never adjust the fuel injection pump when the tractor is moving.
•
Never lubricate the tractor when the engine is running.
•
ELECTRICAL SYSTEMS
If it is necessary to use auxiliary batteries, cables must be connected at both sides as follows: (+) to (+) and (-) to
•
(-). Avoid short-circuiting the terminals. GAS RELEASED FROM BATTERIES IS HIGHLY FLAMMABLE. During
INTRODUCTION
87628084B 12/06/2009
4
Find manuals at https://best-manuals.com Find manuals at https://best-manuals.com