New Holland T7030 Service Manual page 14

Ensure that the cables of mobile electrical equipment cannot get trapped and damaged, such as in a vehicle hoist.
Use air operated mobile equipment where possible in preference to electrical equipment.
In cases of electrocution:-
switch off electricity before approaching victim
•
if this is not possible, push or drag victim from source of electricity using dry non-conductive material
•
commence resuscitation if trained to do so
•
SUMMON MEDICAL ASSISTANCE
•
EXHAUST FUMES
These contain asphyxiating, harmful and toxic chemicals and particles such as carbon oxides, nitrogen oxides, alde-
hydes, lead and aromatic hydrocarbons. Engines should only be run under conditions of adequate extraction or
general ventilation and not in confined spaces.
Gasolene (Petrol) Engine
There may not be adequate warning properties of odour or irritation before immediate and delayed toxic or harmful
effects arise.
Diesel Engine
Soot, discomfort and irritation usually give adequate warning of hazardous fume concentrations.
FIBRE INSULATION
see Dusts.
Used in noise and sound insulation.
The fibrous nature of surfaces and cut edges can cause skin irritation. This is usually a physical and not a chemical
effect.
Precautions should be taken to avoid excessive skin contact through careful organisation of work practices and the
use of gloves.
FIRE
see Welding, Foams, Legal Aspects.
Many of the materials found on or associated with the repair of vehicles are highly flammable. Some give off toxic or
harmful fumes if burnt.
Observe strict fire safety when storing and handling flammable materials or solvents, particularly near electrical equip-
ment or welding processes.
Ensure before using electrical or welding equipment but that there is no fire hazard present.
Have a suitable fire extinguisher available when using welding or heating equipment.
FIRST AID
Apart from meeting any legal requirements it is desirable for someone in the workshop to be trained in first aid proce-
dures.
Splashes in the eye should be flushed with clean water for at least ten minutes.
Soiled skin should be washed with soap and water.
Inhalation affected individuals should be removed to fresh air immediately.
If swallowed or if effects persist consult a doctor with information (label) on material used.
Do not induce vomiting (unless indicated by manufacturer).
FOAMS - Polyurethane
see Fire.
Used in sound and noise insulation. Cured foams used in seat and trim cushioning.
Follow manufacturers instructions.
Unreacted components are irritating and may be harmful to the skin and eyes. Wear gloves and goggles.
INTRODUCTION
87628084B 12/06/2009
9