Deck Lift Lock Lever Lockout Plate Operation; Cutting Height Adjustment - Ferris ISX3300BVE37CE Operator's Manual

34
To Adjust the Handle Placement
Loosen the jam nuts and adjust the placement bolt (B) in or
out to properly adjust the lever end spacing.
To Adjust the Handle Height
Remove the mounting hardware and reposition the handle
either up or down from its original position. You will need to
readjust the handle alignment as described above.
Deck Lift Lock Lever Lockout Plate
Operation
The Deck Lift Lock Lever Lockout Plate (A, Figure 35) can be
used to prevent the mower deck from locking the deck in the
TRANSPORT position if you raise deck during operation to
clear an object.
1. Move the deck lift lock lever (A) away from the operating
position, and rotate the deck lift lever lockout plate (B) to
the UNLOCK (C) position (facing towards the operating
position) and allow the deck lift lever lockout plate to
contact the deck height box.
35
The mower deck can now be raised to the TRANSPORT
position without the deck lift lock lever engaging.
28
2. Move the deck lift lock lever away from the operating
position, and rotate the deck lift lever lockout plate (B)
to the LOCK (C) position (facing towards the rear of the
machine) and allow the deck lift lever to return to its
natural position. The mower deck can now be raised to
the TRANSPORT position and the deck lift lock lever will
lock it in place.

Cutting Height Adjustment

The cutting height adjustment pin (A, Figure 36) controls
the mower's cutting height. The cutting height is adjustable
between 1-1/2" (3,8 cm) and 5" (12,7 cm) in 1/4" (0,64 cm)
increments.
36
Note: Make sure that the pin is inserted into the holes in both
upper and lower plates of the pin box (B).
To set the cutting height at 1-1/2" (3,37 cm):
1. While sitting in the operator's seat, press the hydraulic
deck lift button (C) with your foot until the deck locks into
the 5" (12,7 cm) position.
2. Remove the cutting height adjustment pin from the hole
that it is installed in.
3. Press the hydraulic deck lift button and then push the lock
lever (D) towards the right to release the lock.
4. Release the hydraulic deck lift button and gravity will
lower the deck until the deck lift linkage comes to rest
against the stationary pin (E) in the 1-1/2" (3,37 cm)
cutting height hole.
5. Place the cutting height adjustment pin in the storage
hole (F).
To set the cutting height in the range of 1-3/4" (4,40 cm)
and 4-3/4" (12,06 cm):
1. While sitting in the operator's seat, press the hydraulic
deck lift button with your foot until the deck locks into the
5" (12,7 cm) position.
2. Place the cutting height adjustment pin in the desired
cutting height.
ferrismowers.com