Table of Contents
Advertisement
5
Enter the passkey.
Follow the same procedure as in
step 4 of "Pairing this system with a
Bluetooth device" (page 16).
Once pairing is completed and the
connection is established, the system
display changes as follows:
"Connect" Name of the Bluetooth
device
To cancel passkey entry partway
Press
.
Notes
"Passkey" may be called "Passcode, " "PIN
code, " "PIN number" or "Password, " etc.
depending on the device.
This system only supports numerical
passkeys up to 4 digits.
The pairing standby status of the system is
cancelled after about 30 seconds.
If pairing is not successful, redo the
procedure from step 1.
While connected to a Bluetooth device, this
system cannot be detected and a connection
cannot be established from another
Bluetooth device.
Pairing may not be possible if other
Bluetooth devices are present around the
system. In this case, turn off the other
Bluetooth devices.
To erase all the pairing registration
information
1
Press BLUETOOTH
unit.
When the system is connected with a
Bluetooth device (when the Bluetooth
device name or other information
appears in the system display), press
and hold BLUETOOTH
unit for about 2 seconds to put the
system in Bluetooth standby mode.
2
Press CLEAR
"Delete?" appears.
0
GB
on the
on the
.
3
Press
(or ENTER on the unit)
"Complete!" appears and all the
pairing information is erased.
Note
To connect with Bluetooth headphones after
performing this operation, you must enter the
passkey again.
Playing music on this system
You can operate this system from
Bluetooth headphones by connecting the
system and Bluetooth headphones using
AVRCP.
1
Select a function other than the
Bluetooth function.
Press FUNCTION +/ (or
FUNCTION on the unit)
repeatedly.
2
Establish a connection with the
Bluetooth headphones.
Press and hold BLUETOOTH
the unit for about 2 seconds until the
BLUETOOTH indicator
then release the button.
Sound output from the speakers is
stopped.
If more than one Bluetooth device
that has been connected in the past
is present around the system, the
system attempts to connect with up
to 3 most recently connected devices.
(Connection is attempted with up
to 3 devices in order from the most
recently connected device, and the
attempts end when a connection is
established.)
Once the connection is established,
the system display changes as follows:
"Connect" Name of the Bluetooth
device
.
on
lights up,
Hide quick links:
Advertisement
Table of Contents
