3
Start playback.
Press (or BLUETOOTH on
the unit)
Depending on the Bluetooth device,
you may need to start up the AV
software of the Bluetooth device
beforehand.
4
Adjust the volume.
Press VOLUME +/ (or turn the
VOLUME control on the unit)
To check the address of a connected
Bluetooth device
Press DISPLAY
device name appears in the system
display.
The Bluetooth device address appears for
8 seconds.
To cancel the connection with a
Bluetooth device
Press and hold BLUETOOTH
on the unit for about 2 seconds until
"Disconnect" appears, or until the
information on the display (device name,
etc.) disappears.
Other operations
To
Pause playback (or BLUETOOTH
Stop playback
Select a folder
Select a file
Find a point in
a file
Note
These operations may not be available for
certain Bluetooth devices. In addition, the
actual operations may differ depending on the
connected Bluetooth device.
1
GB
.
while the Bluetooth
Press
on the unit)
.
+/
.
/
.
Hold down /
.
Notes on connections with Bluetooth
devices
If you cannot connect with a paired
Bluetooth device, perform the pairing
operation between the system and the
Bluetooth device again.
Depending on the type of Bluetooth device,
you can adjust the volume using the controls
of the Bluetooth device.
When BLUETOOTH
is pressed while connected to Bluetooth
headphones, it may take some time until
.
a connection is made to the system from
another Bluetooth device.
Use the A2DP-capable or A2DP- and
AVRCP-capable Bluetooth device with the
system in a peer-to-peer environment.
Tip
Bluetooth devices that have been connected
with this system in the past are registered with
this system.
When a Bluetooth connection is not
currently established, you can easily
connect the system to a Bluetooth device
by pressing BLUETOOTH
unit. (Connection is attempted with up to
3 devices in order from the most recently
connected device, and the attempts end when
a connection is established.) This function may
not be available depending on the Bluetooth
device you are using.
If a connection cannot be made, the system
returns to the standby mode.
.
on the unit
on the