Exmark LZS850EKA724W0 User Manual page 9

5.1.2 Status of Outputs
This screen lists all of the outputs from the system
and highlights the one currently active. Outputs with
numerical values will display the current value.
1. Status of outputs
2. Speed signal
•
Engine speed signal shows voltage signal sent
from the RED system to the engine ECU (Engine
Control Unit).
•
PTO output (highlights if ON)
•
Engine shutdown output (highlights if ON)
•
Module communication (highlights if LDU and
MCU are communicating)
•
Alarm (highlights if ON)
•
Starter (highlights if ON)
5.1.3 Current Error Messages
This screen displays the current error as text with
the non-resettable engine hours at which the error
occurred. The toggle button allows the user to scroll
between screens if multiple errors are active. If only
one error occurs, the toggle button will not change
screens.
1. Current error
2. Error display (e.g. Low oil pressure)
3. Hour when it occurred
Figure 9
3. Clutch output
4. Engine power to run
Figure 10
5.1.4 Hydraulic Transmission Oil Maintenance
This service reminder screen displays the hours until
the specified maintenance is due.
g038556
1. Hydraulic trans oil
2. Reminder display (e.g. Maintenance hours to service)
3. Remaining hours until service is due
Press the toggle button to also display the
non-resettable engine hours at which every service
reminder reset was performed.
1. Hydraulic trans oil
2. Service history display
3. Service reminder reset was performed (e.g. 250, 750)
5.1.5 Engine Oil Maintenance
This service reminder screen displays the hours until
the specified maintenance is due.
g030185
1. Engine oil
2. Reminder display (e.g. Maintenance hours to service)
3. Remaining hours until service
9
Figure 11
Figure 12
Figure 13
g030186
g030187
g030188