Festool PRECISIO CS 70 EB Original Operating Manual page 16

P R E C I S I O
- Replace a worn or damaged (e.g. bedded in)
tabletop immediately.
- Operating personnel must have received ade-
quate training in the use, set-up and operation
of the machine.
- Faults on the machine, including the separat-
ing guards or the tool, must be reported to
maintenance staff immediately upon discov-
ery. The machine must not be used until the
fault has been eliminated.
- Wear suitable personal protective equipment:
ear protection to reduce the risk of hearing
loss, safety goggles, a dust mask to prevent
inhalation of harmful dust, protective gloves
when working with raw materials and when
changing tools.
- To minimise noise, the tool must be sharpened
and all noise reducing elements (covers etc.)
must be properly adjusted.
- When cutting wood,
chine to a dust extractor corresponding to
EN 60335-2-69, dust category M.
- Never process material containing asbestos.
- Make sure that there is adequate lighting in
the room or workplace.
- Always assume the correct position before
starting work:
- front at the operating end,
- facing the machine,
- next to the cutting line.
- Use the accompanying workpiece holder to
guide the workpiece accurately past the saw
blade.
- Always use the supplied spacer wedge and
the guard. Ensure that they are set correct-
ly as described in the operating manual. An
incorrectly set spacer wedge and removing
components that are required for safety rea-
sons, such as the guards, can result in serious
injuries.
- Use a suitable device to support long work-
pieces and ensure that they are horizontal.
- Pull the plug from the main power socket be-
fore changing tools and rectifying faults such
as removing trapped splinters.
- Do not remove offcuts or other workpiece
parts from the cutting area while the tool is
still running and until the saw blade stops.
- If the saw blade is blocked, switch the machine
off immediately and disconnect the mains
16
connect the ma-
plug. Do not remove the jammed workpiece
until you have done this.
- Cutting rebates or grooves is only permitted
with a suitable protective device fitted, e.g. a
protective tunnel over the saw table.
- You must re-install the safety equipment im-
mediately after work that requires the guard
to be removed, see sec. 6.1.
- Do not use circular saws for cutting slots
(grooves in workpiece).
- Before transporting the machine, make sure
that the top protective guard covers the top
section of the saw blade.
- Do not use the upper guard as a handle for
transportation!
- When not in use, store the push stick in the
holder provided on the machine.
- Only for AS/NZS: The tool shall always be sup-
plied via residual current device with a rated
residual current of 30 mA or less.
5.2 Emission levels
Noise emissions have been measured in accord-
ance with the specifications in EN 61029. These
specifications apply for operation as a trimming
saw and bench-mounted circular saw.
Noise level
Sound power level, idling
Sound power level,
during operation
Measuring uncertainty allowance
Workplace emission levels
Workplace emission, idling
Workplace emission,
during operation
CAUTION
The noise produced during work may damage
your hearing.
fWear ear protection!
Measured acceleration
The specified emissions values (vibration, noise)
– are used to compare machines.
– They are also used for making preliminary
estimates regarding vibration and noise loads
during operation.
– They represent the primary applications of the
power tool.
Increase possible for other applications, with oth-
er insertion tools or if not maintained adequately.
Take note of idling and downtimes of machine!
91 dB(A)
103 dB(A)
K = 3 dB
77 dB(A)
90 dB(A)
< 2.5 m/s²