Lincoln Electric POWER FEED 25M Operator's Manual page 24

B-8
SMAW (Stick) Welding Display
MSP4 OPERATION
CC STICK MODES
PROCESS
Stick Soft(7018)
Stick Crisp(6010)
ARC CONTROL
ARC FORCE
(Soft)-10.0 to
(Crisp)+10.0
All manuals and user guides at all-guides.com
OPERATION
194
WFS
LESS
AMPS
MODE
1
2
IR PORT
WELD MODE
ARC CONTROL
DESCRIPTION
Lower values will provide less short
circuit current and a softer arc.
Higher settings will provide a higher
short circuit current, a more forceful
arc and possibly more spatter.
POWER FEED™ 25M
FIGURE B.3
0
AMPS VOLTS
MORE
OUTPUT
AMPS
OFF
START OPTIONS
START TIME:
If no remote control is installed,
0 to 10 seconds
this control sets the time for
the weld output to ramp up or
down from a preset Start cur-
rent to the preset Weld current.
Use the WFS/AMP knob to
adjust Start current while the
Start Options LED is displayed.
WAVEFORM CONTROL TECHNOLOGY
Stick
I
I
CC Stick Soft
SET
No arc ending options are active for
SMAW (Stick) welding modes.
n
TRIM
OUTPUT
ON
FUNCTION
SETUP
START OPTIONS
END OPTIONS
END OPTIONS
B-8