Braun MultiQuick 7 Instructions Manual page 13

Use the «hc» chopper (10) for smaller
quantities and fine results.
Use the «ca» chopper (11) for larger quan-
tities and for hard foods.
Maximum operation time for the «hc»
chopper: 15 seconds. Max. amounts 3 oz
/ 85 g. Immediately stop processing when
motor speed decreases and/or strong
vibrations occur.
For best results of hard food processing
fill the bowl of «ca» chopper (11) with max.
10.5 oz / 300 g. Not suitable for liquids.
Refer to the Processing Guide D for maxi-
mum quantities and recommended speeds.
Before Use
• Pre-cut foods into small pieces for
easier chopping.
• Remove any bones, tendons and gristle
from meat to help prevent damage to
the blades.
• Make sure the anti-slip rubber ring
(10d/11d) is attached to the bottom of
the chopper bowl.
Assembly and Operation
• Carefully remove the plastic cover from
the blade.
• The blades (10b/11b) are very sharp!
Always hold them by the upper plastic
part and handle them carefully.
• Place the blade on the center pin of the
chopper bowl (10c/11c). Press it down
and give it a turn so that it locks into place.
• Fill the chopper with food and put on
the lid (10a/11a).
• Align the chopper with the motor part
(4) and click together.
• To operate the chopper, switch on the
appliance. During processing, hold the
motor part with one hand and the
chopper bowl with the other.
• Always chop harder foods (e.g. parme-
san cheese) at full speed.
• When chopping is complete, unplug
and press the EasyClick release buttons
to detach the motor part.
• Lift the lid up. Carefully take out the
blade before pouring out the contents
of the bowl. To remove the blade,
slightly turn it then pull it off
Caution
• Do not use the chopper accessories
(10/11) with chopping blades to pro-
cess extremely hard foods, such as
unshelled nuts, ice cubes, coffee
beans, grains, or hard spices e.g. nut-
meg. Processing these foods could
damage the blades.
• If using the appliance to purée hot food,
allow hot food to cool slightly to avoid
risk of scalding.
• Do not use the chopper accessory to
process hot liquids.
• Never place the chopper bowl in the
microwave oven.
Food Processor Accessory
The food processor accessory (12) can
be used for:
• Chopping, blending and mixing light
batter;
• slicing, shredding, julienning, and mak-
ing french fries.
Chopping (E)
Using the blade (12h) you can chop meat,
hard cheese, onions, herbs, garlic, vege-
tables, bread, crackers, and nuts.
For processing liquids the quantity should
not exceed 1/2 of working bowl. For best
results of hard food processing fill the con-
tainer with max. 700 g (24.5 oz).
Refer to the Processing Guide E for maxi-
mum quantities and recommended speeds.
Before Use
• Pre-cut foods into small pieces for eas-
ier chopping.
• Remove any bones, cartilage, tendons
and gristle from meat to help prevent
damage to the blades.
13