Chapter 7 Operation With A Terminal Program; Connecting With A Terminal Program; Closing The Connection With A Terminal Program; Additional Parameters - Bosch VIP XD Installation And User Manual

VIP XD | Installation and User Guide
Operation with a terminal program
As well as using Microsoft Internet Explorer, you can also control the
establishment of a connection from the VIP XD using a terminal program, for
example the HyperTerminal program that is part of Windows.

Connecting with a terminal program

Various requirements must be met in order to operate using a terminal program
(see page 19).
– Start the terminal program and enter the command 1 in the main menu to
switch to the IP menu.
– Enter the command 4 in the IP menu to change the remote IP address, then
enter the IP address of the device to connect to.
– Use the command 0 to return to the main menu.
– Enter the command 4to switch to the Rcp+ menu.
– Enter the command 5 in the Rcp+ menu to activate the automatic connection.

Closing the connection with a terminal program

– Start the terminal program (see page 19); enter the command 4 in the main
menu to switch to the Rcp+ menu.
– Enter the command 5 in the Rcp+ menu to deactivate the automatic
connection.

Additional parameters

Using the terminal program, you can check other basic parameters and modify
them where necessary. Use the on-screen commands displayed in the various
submenus to do this.
Bosch Security Systems | 2005-05 | V1.0
EN | 67
7
Operation with a terminal program