Destination Password - Bosch VIP XD Installation And User Manual

EN | 38
Installation and User Guide | VIP XD
IP addresses which will be selected in order by the unit in case of an alarm until
a connection is established.
Connect on alarm:
Select On so that the VIP XD automatically establishes a connection to a pre-
defined IP address in the event of an alarm.
With the setting Follows alarm 1, the VIP XD automatically establishes a
connection to a remote station and maintains it for as long as an alarm signal is
present at alarm input 1. This option can also be used to connect two units
(transmitter and receiver) via a switch connected to the VIP XD. In this case, no
computer is needed to establish the connection.
Number of destination IP address:
Here you assign the numbering for the IP addresses to be contacted in the event
of an alarm. The unit contacts the remote locations one after the other in the
numbered sequence until a connection has been established.
Destination IP address:
For each number, enter the corresponding IP address for the desired remote
location.

Destination password:

If the remote location is password protected, enter the password here.
Auto-connect:
Select the option On if an active connection should be re-established
automatically to one of the previously specified IP addresses after each restart,
after a connection breakdown or network failure.
Configuration using a Web Browser Bosch Security Systems | 2005-05 | V1.0