Offset X/Offset Y - Canon iR2230 Printer Manual

Offset X/Offset Y

2
2-12
Settings Menu
-50.0 to +50.0 mm (in increments of 0.5 mm); 0.0
This setting sets the offset position in millimeters. The settings can be set between -50.0 mm
(-2.00 inch) and +50.0 mm (+2.00 inch) in increments of 0.5 mm (0.01 inch).
The print position is adjusted in the vertical or horizontal direction to the value specified in the
setting value.
You can increase or decrease the setting in increments of 0.5 mm (0.01 inch) to adjust the print
position, as described below.
Offset X: Increasing the setting value moves the image in the rightward X direction on the
paper. Decreasing the setting value moves the image in the leftward X direction on the paper.
Offset Y: Increasing the setting value moves the image in the downward Y direction on the
paper. Decreasing the setting value moves the image in the upward Y direction on the paper.
ABC DEF
Adjust using
X/Y-Adjustment
Front Back
IMPORTANT
Please note that if the print position is adjusted to place print data outside the valid print area, the
portion outside the valid print area is not printed.
NOTE
If this setting is used in combination with the Margin setting, the values of the two settings are
added together.
Pressing [ ] increases the setting value by 0.5 mm (0.01 inch) each time the key is pressed.
Pressing [ ] decreases the value by 0.5 mm (0.01 inch) each time. Holding down either [
or [ ] continuously speeds up the value alteration.
*
mm
Area adjusted using
X-Adjustment
[+]
X X
Y Y
ABC DEF
Front Back
Part of the
original margin
]