Table of Contents
Advertisement
20
4. Secure the cable close to the I/O drive unit, making sure there is
5. Complete another hardover check: use the steering wheel to move
Figure 19:Connections at course computer
4. Post-installation check
WARNING:
Keep clear of moving steering systems at all times. Protect
moving parts from access during normal use.
Check the following points after installing the drive:
1. Is the drive unit securely attached to the steering system (with all
2. Is the drive unit correctly aligned?
3. Are the motor and clutch cables correctly routed and securely
4. Complete a hand-steering check: Are you sure there is no contact
Note: When you have installed the entire autopilot system, you will
need to complete an autopilot steering check. Refer to the control unit
handbook for more details.
All manuals and user guides at all-guides.com
enough free length to allow the drive unit to move.
the rudder from hardover to hardover, and check that the cable
does not catch on any part of the boat or its fittings.
Type 150/400 course computer
–
+
–
A
B
OFF
POWER
MOTOR
SOLENOID
SWITCH
blue
brown
brackets, bolts, split pins, etc. secure)?
connected to the course computer?
between the drive unit and any part of the engine, steering system
or boat's structure when the push rod moves in and out?
I/O Drive - Installation Guide
Type 100/300 course computer
+
–
–
–
+
lk CLUTCH
CLUTCH
black
red
black
–
+
1
2
POWER
MOTOR
red
blue
brown
D5184-2
Advertisement
Table of Contents
