Table of Contents
Advertisement
All manuals and user guides at all-guides.com
I/O Drive - Installation Guide
Figure 9: Fitting the adaptor pin bracket (Mercruiser 93/OMC/Yamaha)
3. Fit the I/O drive into the girdle support bracket (see Figure 10):
Figure 10:Fitting the I/O drive unit (Mercruiser 93/OMC/Yamaha)
CAUTION:
The fixed and spring-loaded location pins must be fully engaged
in the I/O drive girdle tube. If they are not the autopilot will fail.
• make sure that the bracket is vertical and that the securing
bolts are on the bow (forward) side of the cable end sheath
• tighten the two securing bolts on the adaptor pin bracket
Adaptor pin
Forward
bracket
• position the I/O drive unit so the fixed support pin (on the
bracket) fits into the location hole in the I/O drive girdle tube.
• twist and lower the I/O drive unit into the bracket until the
spring-loaded pin fits into the other location hole
165 mm (6.5 in)
Cable
end sheath
I/O drive girdle tube
11
D3370-2
D3371-2
Advertisement
Table of Contents
