Table of Contents
Advertisement
Available languages
Available languages
Manual instruction | Marble cutter
Operating instruction
•
The tool has to be switched off before saw
blade (7) touches the semi-finished piece. Do not
apply too much force; the operation has to last.
Excessive force applied will not accelerate the job,
and will result in the tool overload.
•
Hold the power tool with both hands by both
handles, as it will provide for the required control
of the tool.
•
Do not use the tool to curve line or bending
angle, otherwise the blade will damage and
reduce its function.
Setting the cutting depth
The power tool design enables the stepless cutting
depth adjustment. An accurate cut can be achieved,
if the cutting blade (7) overhangs the material by ca.
3 mm.
1.
Loosen the clamping
screw of the cutting depth
ruler (12)
2.
Set the desired cutting
depth in accordance with
the reading on the cutting
depth ruler scale (1)
3.
Tighten the clamping
screw of the cutting depth ruler (12)
Adjusting the cutting angle
The power tool design enables the stepless cutting
angle adjustment within the range from 0° to 45°.
1.
Loosen the clamping
screws (5)
2.
Set the desired cutting
angle in accordance with
the reading on the case
inclination ruler scale (4)
3.
Tighten the clamping
screws (5)
Maintenance and cleaning
Before any work on the machine itself, pull the
mains plug.
Continued use of a worn or damaged cutting blade
will result in reducing cutting efficiency and may
seriously overload the motor. Inspect the cutting
blade often and replace it with a new blade as
necessary. Inspection the mounting screws regularly
and ensure that they are properly tightened, failure
EN
to do so could result in serious injury or hazard.
Always keep the machine and the ventilation slots
clean. Should the machine fail despite the rigorous
manufacturing and testing procedures, repair
should be carried out by an authorized customer
services centre for IVT power tools.
Environmental protection
Recycle raw materials instead of disposing
as waste.
Machine, accessories and packaging should be
sorted for environment-friendly recycling.
he plastic components are labelled for categorized
recycling.
These instructions are printed on recycled paper
manufactured without chlorine.
6
Advertisement
Table of Contents
