https://arttel.ru/
Connection Example
To connect the GDS either by using PoE or PSU follow steps below:
•
Open the Back-Cover Board of the GDS3710 which should look like following figure.
Power the unit using PoE
•
Cut into the plastic sheath of your RJ45 cable, then Unwind and pair the colors like shown below.
•
Connect each color of the RJ45 to its associate on the Back Cover of the GDS3710, this way user
can power the unit using PoE.
Power the unit using PSU
•
To power the unit using PSU, use a multimeter to detect the polarity of your Power Supply, then
connect GND to negative pole and 12V to positive pole of the PSU.
https://arttel.ru/shop/ip-domofony/grandstream-gds3710
Figure 5: GDS3710 Back Cover
Figure 6: Connection Example
GDS3710 User Manual
P a g e
|
20